• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Why Buy a 10kg Front Loader?

The 10kg front loader is ideal for Www.023456789.xyz large laundry loads, www.023456789.xyz with plenty of room for large wash cycles and 13 wash programs, including handwash. With its smart technology and advanced features, it's the ideal partner for your home laundry.

Front loaders generally take longer to wash, are not available in larger capacities, and 023456789 often suffer from mould and mildew. But they are more energy and water efficient than top loaders.

Energy

The major energy expense of the front loader with 10kg of weight is the power used to heat water to operating temperature, and to run the motor. These costs can be offset by lower energy consumption when compared with top-loaders. This includes less power used during the spin cycle and agitation cycle and the use of less water. Some machines offer low-water cycles that use less water than the cotton cycle. This saves both water and 023456789 energy.

In general, true front-load washers use less detergent than top-loaders and the tumbling motion in the drum is able to entrain air, 023456789.xyz reducing foamy suds and overflows without lessening cleaning action. However the door seals and bellows are more susceptible to wear than those in top-loaders. In addition, a top-loader's mechanical agitator could cause significant wear and abrasion of fabrics for clothing, since it pushes clothes against each with paddles that are constantly dropping and dragging them through the wash. This abrasion is measured by the amount fabric that accumulates on the clothes dryer's lint screen, as lint is primarily composed of stray fibers that are removed from clothing while washing and drying. Many top-loaders have been designed to run at slower speeds, and could also include the "freshening cycle" to clean the bellows or mechanical gears regularly.

Water

Top-load washers require an impeller or agitator to push detergent and water through clothes, which creates mechanical wear and abrasion. By contrast, front-loaders use paddles that gently lift and drop clothing inside a drum spinning to clean, reducing wear. The amount of lint in dryer lint filters can be used to estimate the rate of wear. Lint is largely made of threads which are removed from clothes while washing and drying.

Front-loading machines are less likely to leak due to a lower water level than top-loaders. True front-loaders will require a bellows seal or seal to prevent water from getting out of the door during operation, however these systems typically do not need to be maintained at the same frequency as their counterparts on top-loaders.

Additionally, front-loaders can operate with cold water or hot and a lot of them without any external heating source, making them more energy efficient than most top-loaders. This efficiency can reduce the cost of running the same laundry load, especially in areas where water, detergent and energy are expensive.