• 목록
• 답변
• 글쓰기
• 게시판 리스트 옵션
  • 수정
  • 삭제

Fiat 500 Replacement Key Fob

If your 500 remote key fob has stopped working, it may be time to replace the battery. If you do replace the battery but it doesn't work it is probably elsewhere.

At United Locksmith, we specialize in the creation of new keys for old cars. We have the tools and spare parts needed for this job.

Dead Coin Battery

The most common reason why your fiat 500 remote key programming 500 key fob will not lock or unlock the doors is a dead battery. The key fob is equipped with the battery of a coin-cell that is prone to draining quickly in the event that it is not frequented enough. If your remote began to show signs of weakness like a loss of range and then completely stopped working The battery is probably dead.

Metal clips hold the battery in inside the key fob. If the clips are loose they could cause contact issues, which could prevent your remote from receiving power. Make use of a flathead screwdriver to remove the retaining clip and remove the old battery. Make sure you use a replacement battery with the same type of voltage, dimensions, and specification as the original battery.

The key fob could also be damaged or corroded by exposure to water. Even a brief bath in warm, soapy water can cause damage to the chip. Keep your key fob dry.

Water Damage

Water damage could be the cause of your key fob's not functioning properly. Key fobs come with rubber seals that prevent them from being damaged by rain or a splash of water, however it is vital to keep your keys from being tossed into the ocean, pool, and the washing machine!

The key fob is equipped with an electronic chip which sends a message to the immobilizer system of your car. The chip allows the 500 to be locked and started. If it gets wet, it will no longer function.

You can clean the inside of your key fob's electronics with isopropyl alcohol or an electronic cleaner to see whether they're still functioning. However, it's recommended to purchase a replacement from a dealer rather than trying to fix an item that is submerged in salt water.

A replacement fob might cost you a little bit, but it's a lot cheaper than having to have your fiat stilo key 500 towed to a dealership and fixed there! You can also fix it yourself with only a few steps. Just ensure you have the correct type of battery before you attempt to open your key fob. This is a job that's much simpler than it appears and you can find step-bystep instructions on the internet for nearly any car key fob.

Faulty Chip

The chip inside the key fob is in direct communication with the immobiliser on your vehicle to ensure that the vehicle will only start once the correct keys are used. If the chip is damaged or corrupted in any way the car won't start.

Damage to the water or a dead cell battery are the two most frequent causes of defective chips. It is best to hand over the work to a professional locksmith who will be able to replace the chip in a short time and at a an affordable cost.

If your key fob does not function after exposure to clean tap or rain water, remove the battery. Clean the electronic component with a paper towel. If the key fob still isn't working it's most likely an issue with the chip and is required to be replaced.

Some people will turn to their dealer when in need of an entirely new Fiat key fob, however this could be a expensive option. United Locksmith is the best place to go if you are looking to have your fiat car keys cut keyfob fixed at a reasonable price. We have the tools and knowledge necessary to repair your fiat punto keys key fob in a quick and professional way.

Faulty Receiver Module

Fiat key fobs send a signal to the vehicle that can unlock and close doors (and start the vehicle for those with an automatic transmission) up to 50 feet. There are many reasons why the fob might stop working. This includes a dead coin battery, water damage buttons, worn out buttons, a receiver module issue, and signal interference or an electronic chip malfunctioning.

If the fob was stored in a place that has been subject to extreme trauma, like being dropped on a hard floor or getting washed in a washing machine the fob may not be capable of communicating with the car's Body Control Module (BCM). This is because the BCM is a secure system that will only accept a signal from a genuine original key and not any other.

You'll need to replace the fob in case this happens. A professional locksmith can handle all aspects of the key replacement process, including programming a new one for your 500. They can even provide an identical fob that functions just like the original (and costs only one-third of the cost).